User manual ZYXEL PLA4201 FICHE TECHNIQUE

[. . . ] · ZyXEL Web Site Please refer to www. zyxel. com for additional support documentation and product certifications. Customer Support In the event of problems that cannot be solved by using this manual, you should contact your vendor. If you cannot contact your vendor, then contact a ZyXEL office for the region in which you bought the device. See http://www. zyxel. com/web/contact_us. php for contact information. Please have the following information ready when you contact an office. [. . . ] In other words, if the Local powerline adapter is selected in the Configuration screen, then this table will display the rates of transmission from the powerline adapter connected to the computer running the configuration utility to all the Remote powerline adapters. Site This field displays: · · MAC Address Local, if it is the PLA4201 directly connected to the computer running the configuration utility. Remote, if it is a PLA4201 in your powerline network but not directly connected to the computer running the configuration utility. This field displays the MAC address of your powerline adapter. The MAC address of your powerline adapter can be found by looking at the label on your device. It consists of six pairs of hexadecimal characters (hexadecimal characters are "0-9" and "a-f"). In the case of the PLA4201, this label is on the bottom of the device. This field displays how fast information is sent from the powerline adapter selected in the Configuration screen to this powerline adapter. The rate is given in the following format: "application data transmission rate / raw data transmission rate". Application data reflects more accurately how fast devices are transmitting application relevant traffic (for example Internet Protocol (IP) traffic). Raw data refers to the whole payload of the packets transmitted across the powerline network. This field displays how fast information is received from the powerline adapter selected in the Configuration screen to this powerline adapter. Different powerline networks are identified by the Ethernet interface (network card) on your computer which is connected directly to a powerline adapter. However, if your computer has two network cards and both are connected to a powerline adapter, then you have two powerline networks. This field displays: · · Local, if it is the PLA4201 directly connected to the computer running the configuration utility. Remote, if it is a powerline adapter in your powerline network but not directly connected to the computer running the configuration utility. Site MAC Address This is a read-only field which shows the MAC address of the powerline adapter you are configuring. You can find the MAC address of your PLA4201 displayed on a sticker on the bottom of your device. Select a priority setting from the drop-down box for traffic FROM your selected device. The options, in order of importance, are High, Medium, Normal and Low. The new Priority setting is applied to the selected powerline adapter. Priority Save 4. 7 About Screen Use the About screen to view information regarding the configuration utility and firmware version of the PLA4201 you are connected to. Click the icon in the top right corner of the utility to view the About screen. Figure 18 About Screen Upgrade to latest version firmware and utility. 34 PLA4201 User's Guide Chapter 4 The Configuration Utility The following table describes the labels in this screen. Table 7 About Screen LABEL Utility version: Firmware version DESCRIPTION This field displays the software version of the configuration utility. [. . . ] ZyXEL is not responsible for any loss of or damage to any data, programs, or storage media resulting from the use, misuse, or disuse of this or any other ZyXEL product. Trademarks ZyNOS (ZyXEL Network Operating System) is a registered trademark of ZyXEL Communications, Inc. Other trademarks mentioned in this publication are used for identification purposes only and may be properties of their respective owners. Certifications Federal Communications Commission (FCC) Interference Statement The device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: · This device may not cause harmful interference. PLA4201 User's Guide 53 Appendix A Legal Information · This device must accept any interference received, including interference that may cause undesired operations. This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. [. . . ]